Material Safety Data Sheet for Milk Paint Remover

Distributed by:

View printer friendly version

The Real Milk Paint Co.
11 West Pumping Station Road
Quakertown, PA 18951
Phone: 215-538-3886
Fax: 215-538-5435

Product Name: Milk Paint Remover
Trade Name & Synonyms: Powder Paint Stripper
Chem-Tel Inc. Phone Number: 800-255-3924

Section 1. – Identification

Effective Date: October 18, 2010
Trade Name: The Real Milk Paint Company
Chemical Name: N/A
Chemical Family: Alkaline Family
CAS Number: N/A
Chemical Formula: N/A

Section 2. – Composition, Information on Ingredients

Hazardous Ingredients: Calcium Hydroxide
CAS #: 1305-62-0
Approximate Weight %: 30-40%
ACGIH (TLV): 5mgms/m3

Section 3. – Physical Data

Boiling Point: N/A
PH: N/A
Volatiles- Weight%: N/A
VOC'S-Weight%: N/A
Vapor Pressure: N/A
Vapor Density (air=1): N/A
Solubility in Water: Appreciable
Oder and Appearance: Odorless, white powder
Specific Gravity: N/A

Section 4. – Fire & Explosion Hazard Data

Flash Point and Method: Non-flammable
Lower Explosion Limit: N/A
Upper Explosion Limit: N/A
Extinguishing Media: Product is non-flammable
Special Fire Procedure: N/A
Unusual Fire Hazard: None

Section 5. – Health Hazard Data

Effects of Overdose

Acute:	Eyes: May cause eye irritation Skin: May cause skin irritation Inhalation: Not Likely Ingestion: Not Likely
Chronic:	No chronic ill effect known or expected

First Aid Procedures:
Eyes: Flush eyes out with plenty of water if irritation persists, get medical attention.
Skin: Wash skin with plenty of soap and water. Remove contaminated clothing and wash before re-use. If irritation on skin persists, get medical attention
Inhalation: Move to fresh air
Ingestion: Move to fresh air

Section 6. – Reactivity Data

Chemical stability: Stable
Conditions to Avoid: None
Incompatible Materials: Acids
Hazardous Decomposition: N/A
Special Considerations: None

Section 7. – Environmental Protection Procedures

Leak and Spill Procedures:
Spills; Sweep up product if on land; if in water ways minimize the spread of product. Neutralize with strong acid where necessary.

Storage Requirements:
Store product at moderate temperatures (55-85 degrees F)

Waste Disposal:
If a spill occurs sweep up product; if a spill is in or near water minimizes the spread of the product. Dispose the material in accordance with federal, local and state regulations

Section 8. – Special Protection Information

Respiratory Protection: Lightweight Filter Mask
Ventilation: Local-preferred. Mechanical- acceptable
Protective Gloves: Gauntlet type gloves
Eye Protection: Chemical goggles
Other: Long pants extending over boots, long sleeved shirt with a button collar

Section 9. – Shipping Information

DOT Shipping Name: Not regulated
Hazard Class: N/A
ID Number: N/A
DOT Label Required: N/A
Dot Hazardous Substance Required: N/A
Special Shipping Information: Not classified as hazardous materials by DOT and is not regulated by Transportation of Dangerous Goods when shipped by any make of transportation

Section 10. – Sara Title III

Section 313 Supplier Notification
This product contains the following toxic chemicals subject to the reporting requirements of Section 313 of the Emergency Planning And Community Right-To-Know-Act of 1986 and of 40 CFR 372

CAS #: None
Chemical Name: None
Percent of Weight: None

Section 11. – Government Regulations

All ingredients are on the TSCA 8(b) Inventory

Section 12. – Additional Comments

Comments: Operators should practice good personal hygiene. Wash with soap and water after exposure. Remove contaminated clothing and wash before re-use.

Product Use: FOR INDUSTRIAL USE ONLY
In accordance with good industrial practice, handle with due care and avoid any unnecessary personal contact

Disclaimer:

Information contained herein is, to our best knowledge, true and accurate. It is offered for information only, as we cannot guarantee the results of processes not under our direct control

***N/A-Not Applicable***